And when applying multiple layers of oil-based wood filler, you need to wait at least 20 minutes after applying the first layer before another layer can be applied. Keep to these simple guidelines, and your project will go well. You need to wait for the wood filler to dry before staining it, otherwise the stain won’t set properly and discoloration is a likely result. Wood fillers, though, can take either paints or stains. ![]() It also can be used inside or it can be painted over after it has fully cured. May be painted with latex-based paint immediately after sanding, or. Outdoor wood putty is made to match popular stain colors for decks and fences. Yes, you can Put in the filled, let it dry, then lightly sand the area, before painting. You can always lightly sand afterwards and put another light coat of primer in those areas. Limit putties to woods that have been stained. Stain before filling with wood filler, then use stain to develop desired final finish. Yes, go ahead and wood fill now before the nice paint goes on. Afterwards treatment with various Osmo oilwax finishes can be carried out.Īny dirt or stains left behind by Osmo Wood Putty can be cleaned quickly with water. Additionally, wood putty and paint do not work well together. Most of the time, fine sanding with P100 – 120 is enough. After 30 – 60 minutes the dried paste can be coarsely (grit P80) and afterwards finely (grit P100 – 120) sanded so that no wood putty is left on the surface of the parquet. Patch holes in PVC trim boards with acrylic filler. Allow the epoxy to hardened overnight, then sand it smooth. Repair damage to exterior surfaces with two-part epoxy. To fix large cracks and gouges on interior surfaces, use auto-body filler. We recommend stirring sanding dust and putty into a homogenous paste in a separate container.įill flooring diagonally with a rust-free double blade scraper and at the same time press wood putty firmly into joints. Overfill the hole slightly, then wipe away the excess filler with a clean cloth. Close lid tightly after use to prevent drying out. ![]() In this case, please reduce the amount of sanding dust. If required, apply another layer of Selleys Wood Putty and allow to dry, before sanding. ![]() TIMBERMATE can be mixed with any stains before or after. If the paste is too thin, it leaves behind unfilled holes.įibrous sanding dust (especially from tropical wood species) can lead to bad mixing properties and this can prevent joints from being filled. Apply wood filler to repair the issue and then apply a dedicated wood staining agent to try to match the color of your pre-existing wood. TIMBERMATE Woodfiller is an interior grade wood putty, grain filler, edge filler and crack filler. If it is too thick, there is insufficient adhesion to the sides of the joint and putty will be removed while sanding. The right paste consistency is important for a flawless application. 15 % weight increase by adding sanding dust). Before applying, stir putty in packaging well so that any sediment is mixed in.īy adding sanding dust, if possible from the same type of wood with a grain size of 80-120, mix into thick paste (approx.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |